How to Make an Indoor Camping Hammock Setup in < 15 min

Although we prefer the great outdoors for our hammock camping, from time to time it is quite nice to have the ability to enjoy a hammock setup right from the comfort of our home. When not out in the woods, a hammock camping setup can easily be used indoors to relax or even change up the routine and sleep in once in a while. Here are the steps we used to make an indoor hammock setup in < 15 minutes: 


Step #1 - Gather Tools and Materials Needed

The picture below shows all the tools and materials you'll need for the job. Tools needed include an electric drill, drill bit, measuring tape, screwdriver, and stud finder. Take note of what you have on hand and pick up anything you don't already have at the hardware store in step 2. 


Step #2 - Acquire Proper Lag Bolts

While I'm sure a variety of hardware would work here, I can only tell you what I've used and had work for me. This step is pretty simple. Just go to your closest home improvement store (e.g. Lowe's, Home Depot) or a local hardware store like Ace Hardware, and look for closed eye lag bolts in the hardware section. This is what I got:  


At ~170 lbs, these have worked very well for me. I'm fairly sure these will hold more weight but always use caution. If you're unsure about what to get, just find someone in the store and tell them what you're looking for and why. Be sure that the threaded portion of the bolt is long enough to screw deep into the ceiling beams for a strong hold. The threaded portion on these is about 2" long for reference.   


Step #3 - Find Suitable Location to Hang 

All you really need to do here is find an area in the house where you can hang your hammock without any obstructions. You'll want to choose your space based in part on the length of your hammock. For my Original Appalachian Hammock @ 11', I ended up choosing an area where I could span 13.5' between the lag bolts. It will also make things easier if you don't select the room with the highest ceilings in the house. As an example, I did this project in the basement, which has ~6.5' ceilings.  


Step #4 - Find Beams and Mark Drill holes 

Once you find the general area you want to setup in and determine your span, it's time to find the ceiling beams into which you'll screw the lag bolts. For this, you'll need a studfinder (anywhere from $10-$50, but mine was ~$15). Within the general area you want to put the lag bolt, use the stud finder to locate the closest beam. Scan across the width of the beam, marking the two edges with a pencil. Once you have the edges marked, simply find the midpoint and put an X to mark the drill hole. Now use a tape measure to walk off your chosen span and repeat the process for the other lag bolt position. 


Step #5 - Drill Pilot Holes and Screw in Lag Bolts 

Using an electric drill, drill pilot holes through the wall and into the beam at the spots you marked for the lag bolts in Step #4. You'll want to use a drill bit that's slightly smaller than the diameter of the lag bolt. Also, try to drill the pilot hole deep enough to accommodate the length of the lag bolt. This will make things easier momentarily....


Now you're ready to screw in the lag bolts and get hanging! With your pilot holes drilled, it should be fairly easy to screw in the lag bolts. A handy tip is to stick a screwdriver through the eye of the lag bolt in order to gain some leverage and use 2 hands (almost like turning a wheel). You'll want to screw the lag bolts in past the threads and up to where the eye is close to the ceiling like so:



Step #6 - Hang Your Hammock! 

With your lag bolts properly installed, you now have strong points at which to attach each end of your hammock and complete your indoor camping hammock setup! Attach your preferred suspension (I just used a simple webbing and carabiner combo) and you're ready to hang! Here are some pics of my completed setup:  





That's it! For about $5 bucks and 15 minutes, you now have an indoor camping hammock setup. Now go bask in the glory of your accomplishment. Thanks for reading and post below if you have any questions or comments!  


Happy Hanging,


- Kyle

Appalachian Hammock 



Leave a comment

Comments will be approved before showing up.